Cisco VG202 Donanım Kurulum Kılavuzu - Sayfa 45

Ağ Geçidi Cisco VG202 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco VG202 50 sayfaları. Voice gateways
Ayrıca Cisco VG202 için: Yazılım Yapılandırma Kılavuzu (50 sayfalar), Manuel (10 sayfalar), Donanım Kurulum Kılavuzu (48 sayfalar), Hızlı Başlangıç Kılavuzu (19 sayfalar)

Cisco VG202 Donanım Kurulum Kılavuzu
Chapter 4
Powering On the Cisco VG202 and Cisco VG204 Voice Gateways
Enter the virtual terminal password, which prevents unauthenticated access to the voice gateway through
Step 8
ports other than the console port:
The virtual terminal password is used to protect
access to the voice gateway over a network interface.
Enter virtual terminal password: xxxxxx
Step 9
Respond to the following prompt as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
A summary of the available interfaces is displayed.
Choose one of the available interfaces for connecting the voice gateway to the management network:
Step 10
Enter interface name used to connect to the
management network from the above interface summary: fastethernet4
Respond to the following prompts as appropriate for your network:
Step 11
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 26 subnet bits; mask is /16
The configuration is displayed:
The following configuration command script was created:
hostname VG
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
speed 100
duplex auto
ip address 172.1.2.3 255.255.0.0
!
Step 12
Respond to the following prompts. Enter 2 to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
VG>
OL-15959-01
Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide
Initial Configuration Procedures
4-5