Epson LQ-570+ Ürün Destek Bülteni - Sayfa 14

Yazıcı Aksesuarları Epson LQ-570+ için çevrimiçi göz atın veya pdf Ürün Destek Bülteni indirin. Epson LQ-570+ 16 sayfaları. Sdx acd manager 5.2 printer setup
Ayrıca Epson LQ-570+ için: Ürün Destek Bülteni (20 sayfalar), Ürün Destek Bülteni (5 sayfalar), Ürün Bilgi Kılavuzu (8 sayfalar), Kurulum Kılavuzu (1 sayfalar), Manuel (12 sayfalar), Teknik Özellikler (2 sayfalar), Manuel (8 sayfalar), Servis Kılavuzu (49 sayfalar), Kurulum Kılavuzu (14 sayfalar)

C l h n1 n2 d, . . . dk is the command for printing control codes as data where nl

and n2 are variables and d, . ..d,representthedat&atistobeprintedas

interpreted as characters instead of control codes". Thii command is used primarily

to print displayable characters such as ASCII values 0 through 31 in Registered Tables

1 through 9 which are normally used as

determine the values for nl and n2 perform the following steps.

1. Determine how many ASCII codes will be sent sequentially immediately

following nl and n2

2 Using long division, divide the quantity of ASCII codes that will be sent

sequentially immediately following nl and n2 by 255.

3. The remainder in the quotient is the value for n1.

The whoie number in the quotient is the value for n2

EXAMPLE

1. The symbols for the different suits of a card deck (hearts, diamonds, clubs,

and spades - V', +, 4, and 4) are to be printed. These are each separate

ASCII codes (ASCII codes 2 3.4, and 5 when using the PC437 Character

table).

2 4dividedby255= 0 with a remainder of 4.

3. nl =4

In the Basic programming language, the command would look like this.

Thii command, as listed in the line above, will cause the printer to print the symbols

for the different suits of a card deck (hearts, diamonds, clubs, and spades V', +, 4,

and 4). Another example of using the ESC ( * command is illustrated in the

explanation of the ESC ( t (Assign Character Table) command.

PSB No: P-0082

Page:

14 of 14

control codes (LF, FF,

ESC, etc.)