3Com SuperStack II Kullanıcı Kılavuzu - Sayfa 2
Ağ Yönlendiricisi 3Com SuperStack II için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3Com SuperStack II 6 sayfaları. Switch matrix module
Ayrıca 3Com SuperStack II için: Kullanıcı Kılavuzu (4 sayfalar), Kullanıcı Kılavuzu (9 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Ek Sayfa (1 sayfalar), Önemli Bilgiler (2 sayfalar)
Sayfayı Yazdır
S
UPER
U
SER
Introduction
With the SuperStack
installed into your SuperStack II Switch, you can connect up
to four Switches over high speed links, in a single stack. This
stack can then be managed as a single unit with one IP
address.
The Matrix Module can be installed into the following
models of SuperStack II Switches:
SuperStack II Switch 1100
SuperStack II Switch 3300
A stack can consist of any combination of Switch 1100 and
Switch 3300 units.
You do not need a Matrix Module if you are connecting two
Switches back-to-back. You can connect two units using
the Matrix port located on the rear of the Switch and a
SuperStack II Switch Matrix Cable.
You can find more information on stacking units in the user
guide that accompanies your Switch.
Before Installation
Please read the following information before installing the
Matrix Module.
WARNING: Installation and removal of the module must be
carried out by qualified personnel only. Before installing the
module into a unit, you must first disconnect the unit from
®
S
TACK
G
UIDE
®
II Switch Matrix Module (3C16960)
II S
M
WITCH
the mains power supply. For full safety instructions, refer to
the user guide that accompanies the unit.
AVERTISSEMENT: Confiez l'installation et la dépose de ce
module à un personnel qualifié. Avant d'installer ce module
dans un groupe, vous devez au préalable débrancher ce
groupe de l'alimentation secteur. Pour prendre connais-
sance des consignes complètes de sécurité, consultez le
guide utilisateur qui accompagne ce groupe.
WARNHINWEIS: Die Installation und der Ausbau des
Moduls darf nur durch Fachpersonal erfolgen. Vor dem
Installieren des Moduls in einem Gerät muß zuerst der
Netzstecker des Geräts abgezogen werden. Vollständige
Sicherheitsanweisungen sind dem Benutzerhandbuch des
Geräts zu entnehmen.
Handling the Matrix Module
The Matrix Module can be easily damaged by electrostatic
discharge. To prevent damage, please observe the follow-
ing:
Do not remove the Matrix Module from its packaging
until you are ready to install it.
Do not touch any of the connectors or components on
the Matrix Module.
Handle the Matrix Module only by its edges and front
panel.
Always wear an anti-static wristband connected to a
suitable earth point.
Always transport or store the Module in appropriate
anti-static packaging.
M
ATRIX
ODULE