Toshiba 24 WA20 Series Hızlı Başlangıç Kılavuzu - Sayfa 3
TV Toshiba 24 WA20 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Toshiba 24 WA20 Series 49 sayfaları.
Ayrıca Toshiba 24 WA20 Series için: Kullanım Talimatları Kılavuzu (47 sayfalar)
Sayfayı Yazdır
1
Inserting the batteries into the remote
Remove the screw that secure the battery compartment cover on the back side of the remote control first. Lift
the cover gently. Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover back
on. Then screw the cover back on again.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
rear side of the TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
3
Switching on the TV
In order to turn the TV on from standby mode:
• Press the Standby button on the remote control
• Press the centre of the control switch inwards, located at the rear left hand side
of the TV
-or-
In order to turn the TV on from standby mode:
• Press the Standby button on the remote control
• Press the control button on the TV
satellite
dish
aerial /
cable TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control.
HDMI connection
rear side or rear-left
side of TV
English - 1 -