Arisco BW800 Kullanım Kılavuzu - Sayfa 10

Yıkayıcı Arisco BW800 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Arisco BW800 19 sayfaları. Glass washing machine

9. REPLACING THE DEVICE AND PREPARING FOR START UP

A-WATER İNLET

B-WATER OUTLET

C-POWER CABLE

Open the packing of the device and remove all protective tapes.

Opening the cover of the device, take out the instruction manual.

Place the devices with adjustable legs by adjusting their legs and the device with fixed legs by aligning the ground.

Connect the elbowed part of the supply hose the solenoid valve of the device,the other end,to the tap.

Clamp one end of drainage hose to the drainage outlet of the machine.Connect the other end of it to sewer system

coming from the ground.

Drainage hose must not be twisted, folded, and bent more than 90º

Supply water must be at 50ºC in temperature and 202 to 404 kpa in pressure

If the connection to sewer system on the ground is above the drainage outlet of the machine, a drainage pump must

be used.

If water pressure is higher than 404 kpa, a pressure reducer valve must be used.

If the water pressure is lower than 202 kpa, a water pressurizing pump must be used.

Supply water of the machine must be a 10 to 15 º Fr.

If it is not so, a water softening device must be used.

Drainage line to sewer system on the ground, which drainage pipe was connected to, must have a siphon, in order to

prevent bad smells.

Required voltage a washing machine is 380-400 AC V / 50 Hz.

Make a grounding connection and be sure that this connection has been made correctly.

Be sure that there is energy supply in the system.

On the condition that you have fulfilled all requirement for operating the device, your device is ready for working.

10 / 19