Whirlpool WVU57UC0F Kurulum Talimatları ve Kullanım & Bakım Kılavuzu - Sayfa 12

Havalandırma Davlumbazı Whirlpool WVU57UC0F için çevrimiçi göz atın veya pdf Kurulum Talimatları ve Kullanım & Bakım Kılavuzu indirin. Whirlpool WVU57UC0F 19 sayfaları. 30" (76.2 cm) and 36" (91.4 cm) range hood
Ayrıca Whirlpool WVU57UC0F için: Kurulum Talimatları ve Kullanım & Bakım Kılavuzu (36 sayfalar), Kurulum Talimatları ve Kullanım & Bakım Kılavuzu (36 sayfalar)

Install Range Hood

1. Remove the power supply knockout from the top or rear of

the vent hood (depending on the incoming location of your

home power supply cable) and install a UL Listed or CSA

Approved ¹⁄

" strain relief.

A. Power supply knockout

2. Align the exterior edge of the mounting brackets with the

exterior edges of the upper cabinet.

IMPORTANT: The brackets should touch the upper cabinet.

With a pencil, mark the upper holes on the brackets.

3. Using a #2 Phillips screwdriver, install the drywall anchors.

Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,

install the mounting brackets using the upper holes.

NOTE: For installation to a surface other than drywall, it

is recommended that a qualified contractor determine the

anchoring method.

4. Lift the range hood into place and insert the mounting

bracket tabs through the slots in the back of the range hood.

5. From the inside of the range hood, start a #8-18 x

(4.2 x 16 mm) truss-head screw into the mounting tab (A) on

each side of the range hood as shown in the following inset.

Insert the screws approximately 2 turns into the mounting

tab holes. Bend each mounting tab upward approximately

45°.

A. Mounting tab

6. Lift the range hood into place, positioning the rear slots over

the mounting brackets.

7. Using a Phillips screwdriver, push on the screws that are

started into the top mounting tabs and bend the tabs against

the cabinet side walls. Attach the screws to the cabinet side

walls.

8. For direct wire installations, run the home power supply

cable according to the National Electric Code or CSA

standards and local codes and ordinances. There must be

enough wiring from the fused disconnect (or circuit breaker)

box to make the connection in the range hood electrical

terminal box.

9. Tighten the strain relief screws.

NOTE: Do not reconnect power until the installation is

complete.

OPTIONAL: If you prefer, bend the rear tabs against the rear

of the range hood and attach to the wall using #8-18 x

(4.2 x 16 mm) truss-head screws.

⁄