Yamaha Arius YDP-S51 Kullanıcı El Kitabı - Sayfa 24
Elektronik Klavye Yamaha Arius YDP-S51 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha Arius YDP-S51 37 sayfaları. Owner's manual
Ayrıca Yamaha Arius YDP-S51 için: Hızlı Kullanım Kılavuzu (2 sayfalar), Referans Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Advanced Operations
Recording Your Performance
This instrument lets you record your keyboard performance as the User Song. Up to two Parts (left-hand and right-hand)
can be recorded separately.
Recording Your Performance
1
Select the desired Voice and other parameters, such as beat,
for recording.
For instructions on selecting a Voice, refer to page 16. If necessary, set other
parameters, such as beat and effects, in this step.
2
While holding down [REC], press [+R] or [–L] to engage
Record Ready mode for the Part you want to record.
If you do not intend to record right- and left-hand Parts separately, record the entire
performance to either Part.
Recording the right-hand Part ([+R])
Recording the left-hand Part ([–L])
After a while, the [REC] lamp and the selected Part lamp will flash at the current
tempo.
To exit from Record Ready mode:
Simply press [REC].
If data has already been recorded to the other Part:
The data in this Part will be played back while recording. This Part can be turned off
or on by holding down [PLAY] then pressing this Part button.
3
Play the keyboard or press [PLAY] to start recording.
The [REC] lamp lights up while the Recording Part lamp flashes at the current
tempo.
4
Press either [REC] or [PLAY] to stop recording.
The [REC], [PLAY], [+R] and [–L] lamps flash, indicating that the recorded data is
being stored. After the Save operation is completed, the lamps will turn off,
indicating that the Record operation has been completed.
24
YDP-S51 Owner's Manual
or
Recording Capacity
This instrument can record up
to 100KB (approximately
11,000 notes).
NOTE
You can use the Metronome
while recording; however, the
Metronome sound will not be
recorded.
NOTICE
If a Part contains data, the
Part lamp lights. Note that the
Recording operation will
replace already-recorded data
with the new data.
NOTICE
Never turn off the power while
the recorded data is being
stored (while the lamps are
flashing). Otherwise, all
recorded data will be lost.