Yamaha C-5000 Kullanıcı El Kitabı - Sayfa 30

Amplifikatör Yamaha C-5000 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha C-5000 44 sayfaları.

Subsonic filter

Turn on the SUBSONIC FILTER switch to apply the

subsonic filter, as needed.

A resonating turntable tone arm or a warped vinyl record

could cause a very low frequency rumble (subsonic noise)

that might apply load and damage to the speakers. A

subsonic filter will cut such noise to protect the speakers.

Note

The subsonic filter is disabled whenever any audio source

other than the turntable (connected to the PHONO jacks) is

selected as the input source, even if the SUBSONIC FILTER

switch is turned on .

Adjusting the

volume level

Set the gain using the GAIN selector so that you can

make fine volume adjustments.

Gain

Adjust the volume level using the VOLUME control.

Note

If you still hear distortion even if the VOLUME control is

turned down, the signal might exceed the allowable input

level . If the audio source is being input at the balanced

input jacks (BAL 1 or BAL 2), set the ATTENUATOR selector

to ATT . (−6 dB) .