Yamaha YSP-1600 Hızlı Referans Kılavuzu - Sayfa 3

Hoparlör Sistemi Yamaha YSP-1600 için çevrimiçi göz atın veya pdf Hızlı Referans Kılavuzu indirin. Yamaha YSP-1600 27 sayfaları. Digital sound projector
Ayrıca Yamaha YSP-1600 için: Hızlı Referans Kılavuzu (15 sayfalar), Hızlı Referans Kılavuzu (13 sayfalar)

Sayfayı Yazdır

FCC INFORMATION (for US customers)

1 IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this manual,

meets FCC requirements. Modifications not expressly approved by Yamaha may void your

authority, granted by the FCC, to use the product.

2 IMPORTANT: When connecting this product to accessories and/or another product use only

high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all

installation instructions. Failure to follow instructions could void your FCC authorization to use

this product in the USA.

3 NOTE: This product has been tested and found to comply with the requirements listed in FCC

Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides

a reasonable level of assurance that your use of this product in a residential environment will not

result in harmful interference with other electronic devices.

This equipment generates/uses radio frequencies and, if not installed and used according to the

instructions found in the users manual, may cause interference harmful to the operation of other

electronic devices.

Compliance with FCC regulations does not guarantee that interference will not occur in all

installations. If this product is found to be the source of interference, which can be determined by

turning the unit "OFF" and "ON", please try to eliminate the problem by using one of the following

measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line

filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300

ohm ribbon lead, change the lead-in to coaxial type cable.

If these corrective measures do not produce satisfactory results, please contact the local retailer

authorized to distribute this type of product. If you can not locate the appropriate retailer, please

contact Yamaha Corporation of America A/V Division, 6600 Orangethorpe Avenue, Buena Park,

CA 90620, USA.

The above statements apply ONLY to those products distributed by Yamaha Corporation of America

or its subsidiaries.

•

This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS

standard(s).

•

Operation is subject to the following two conditions: 1) this device may not cause harmful

interference, and 2) this device must accept any interference received including

interference that may cause undesired operation.

NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled

environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC

radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the

radiator at least 20cm or more away from person's body.

This transmitter must not be co-located or operated in conjunction with any other antenna or

transmitter.

FOR CANADIAN CUSTOMERS

To prevent electric shock, match wide blade of plug to wide slot and fully insert.

CAN ICES-3 (B)/NMB-3 (B)