ALDI 55945 Kullanıcı Kılavuzu - Sayfa 8
Matkap ALDI 55945 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ALDI 55945 16 sayfaları. 24v lithium-ion cordless drill with hammer action & 2 x batteries
Sayfayı Yazdır
Parts List
Parts List
1.
Drill/Driver chuck
2.
Torque setting/ collar
3.
Function selection collar
4.
Two speed high /low gear selector
5.
Belt Clip
6.
Forward/Reverse & Lock
control/switch
7.
Rechargeable battery display
8.
Variable speed, On/Off trigger switch
for drill, brake, light control,
and battery display
2
14
1
15
13
11
16
10
12
e-mail: [email protected]
MODEL: №. 2024001 • 02/2017 • 55945
24v Lithium-ion Cordless Drill with Hammer Action
9.
Rechargeable battery
10. Charger Adaptor
11. Plug Pack Charger
12. LED work light
13. Hammer function symbol
14. Screw function symbol
15. Drill function symbol
16. Battery pack release
17. Carry Strap
3
4
12
8
AFTER SALES SUPPORT
1800 909 909
24v Lithium-ion Cordless Drill with Hammer Action
Important information – Product care
This drill/driver uses Lithium Ion Battery Cells. Care MUST be taken to ensure
both the safety and life of the pack is maintained. Ensure you have read all of
the safety notes in the previous pages before using the drill/driver.
Treat the battery pack with care and within the guidelines of this manual.
If the pack does become immersed in water or any fluids, or is subject to
a severe drop or it does not operate within the guidelines of this manual,
immediately STOP using the battery pack and have it checked.
During operation avoid overloading the drill/driver. If the drill/driver is
overloaded it will automatically STOP. Overloading may occur for a number
of reasons including when the drill/driver is pushed too hard or when using
a drill/driver bit or attachment greater than what is specified. If you do
overload the drill/driver during operation refer to the "Overload" section in
this manual.
NOTE: When the battery of the drill/driver is at the lower end of the charge,
the drill/driver is more susceptible to the overload condition.
Running the drill/driver at close to maximum load, or continual resetting
of the overload will cause the battery pack to overheat. When a preset cell
temperature is detected, the battery pack will automatically STOP operating
and will not restart until the battery pack has cooled to a safe level.
7
In this condition, DO NOT force cool the pack by placing in a freezer or
6
similar device. Refer to the "Overload" section in this manual.
Another feature of the drill/driver/battery pack is the low voltage cut out
feature. This feature operates when the voltage drops below a preset value.
When this occurs the tool will automatically stop operating. To correct the
situation you need to either insert another charged battery into the drill/
driver or recharge the existing battery, and then proceed with the drill/
driving application.
NOTE: Attempting to restart the tool in this condition without either
5
recharging the battery or installing a battery with charge will lead to drill/
driver restarting and then stopping again after only a few seconds of
17
operation.
These safety devices have been fitted for the safety, reliability and life of the
tool.
9
AFTER SALES SUPPORT
(toll free)
(toll free)
1800 909 909
Product Care
13
e-mail: [email protected]
MODEL: №.2024001 • 02/2017 • 55945