Zanussi ZDT40 Kullanıcı Kılavuzu - Sayfa 18
Bulaşık Makinesi Zanussi ZDT40 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZDT40 28 sayfaları. Zanussi washer dryer brochure
Ayrıca Zanussi ZDT40 için: Teknik Özellikler (7 sayfalar)
Sayfayı Yazdır
household waste disposal service or the shop
where you purchased the product.
Packaging material
The packaging materials are environmentally
friendly and can be recycled. The plastic com-
ponents are identified by markings, e.g. >PE<,
>PS<, etc. Please dispose of the packaging
materials in the appropriate container at the
community waste disposal facilities.
What to do if...
The dishwasher will not start or stops during
operation.
Certain problems are due to the lack of simple
maintenance or oversights, which can be
Fault code and malfunction
• continuous flashing of the start/cancel indicator
light
• 1 intermittent audible signal
• 1 flash of the "end of cycle" indicator light
The dishwasher does not fill with water.
• continuous flashing of the start/cancel indicator
light
• 2 intermittent audible signals
• 2 flashes of the "end of cycle" indicator light
The dishwasher will not drain.
• continuous flashing of the start/cancel indicator
light
• 3 intermittent audible signals
• 3 flashes of the "end of cycle" indicator light
18
CAUTION!
When a unit is no longer being used:
• Pull the plug out of the socket.
• Cut off the cable and plug and dispose of
them.
• Dispose of the door catch. This prevents
children from trapping themselves inside
and endangering their lives.
solved with the help of the indications described
in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the fol-
lowing suggested corrective actions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fitting
at the water inlet valve is blocked.
Clean the filter in the threaded hose fitting.
• The water inlet hose has not been correctly laid or
it is bent or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid or
it is bent or squashed.
Check the water drain hose connection.
• Anti-flood device is activated.
Close the water tap and contact your local Service
Force Centre.