Zanussi ZDT8453 Talimat Kitabı - Sayfa 17

Bulaşık Makinesi Zanussi ZDT8453 için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Zanussi ZDT8453 21 sayfaları.

Sayfayı Yazdır

Maintenance and cleaning

Clean the external surfaces of the machine and control panel

with a damp soft cloth. If necessary use only neutral

detergents. Never use abrasive products, scouring pads or

solvent (acetone, trichloroethylene etc....).

Ensure that the seals around the door, the detergent and rinse

aid dispensers are cleaned regularly with a damp cloth.

We recommend every 3 months to run a 65°C wash

programme without dishes using detergent.

Cleaning the filters

The filters must be checked and cleaned from time to time.

Dirty filters will degrade the washing result.

1. Open the door, remove the lower basket.

2. The dishwasher filter system comprises a coarse/fine filter

(A/B), a microfilter (C) and a flat filter (D).

Some dishwasher will only have a coarse filter (A), a

microfilter (C) and a flat filter (D).

Unlock the filter system using the handle on the microfilter,

and remove.

MA32

3. Turn the handle about

MA36

4. Take hold of the coarse/fine filter (A/B) by the handle with

the hole and remove from the microfilter (C).

5. Clean all filters thoroughly under running water.

6. Remove the flat filter (D) from the base of the washing

compartment and clean both faces thoroughly.

MA31

7. Put the flat filter (D) back in the base of the washing

compartment.

8. Place the coarse/fine filter (A/B) in the microfilter (C) and

press together.

9. Put the filter combination in place and lock by turning the

handle clockwise to the stop. During this process ensure

that the flat filter does not protrude above the base of the

washing compartment.

MA35

a turn anticlockwise and remove.

Under no circumstances may the dishwasher be used

without filters.

Incorrect repositioning and fitting of the filters will

produce poor washing results.

NEVER try to remove the

upper spray arm.

If residues of soil have

clogged the holes in the

upper spray arm, remove

them with a toothpick.

Prolonged periods of non-operation

If you are not using the machine for any period of time you are

advised to:

1. Unplug the appliance and then turn off the water.

2. Leave the door ajar to prevent the formation of any

unpleasant smells.

3. Leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location where the temperature

is below 0°C. If this is unavoidable, empty the machine, close

the appliance door, disconnect the water inlet pipe and empty

it.

Moving the machine

If you have to move the machine (moving house etc....):

1. Unplug it.

2. Turn the water tap off.

3. Remove the water inlet and discharge hoses.

4. Pull the machine out together with the hoses.

Avoid over tilting the machine during transportation.

MA40