Zanussi ZI 457 Talimat Kitapçığı - Sayfa 16

Bulaşık Makinesi Zanussi ZI 457 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZI 457 19 sayfaları.

The dishes are not clean (poor wash)

The baskets are too full.

The dishes have not been arranged properly.

The spray arms do not rotate.

The spray arm holes are clogged.

The water inlet funnel in the centre of the upper

basket is covered by dishes.

The end of the drain hose is submerged in waste

water (in the sink).

The filters are clogged.

The filters are not in position.

Not enough detergent has been used or it is

unsuitable.

The detergent is old or has gone hard.

The salt container cap is not properly closed.

The washing programme selected is too gentle.

Visible lime deposits or white film on the

dishes

There is no salt or the softener has not been

adjusted to the hardness of the water.

The rinse aid has run out or too little is being used

The machine is noisy

The dishes are rattling against each other.

The spray arms are knocking against the dishes.

The dishes are not quite dry

The dishes have been left too long inside the

machine.

The door is difficult to close

The dishwasher is not level or is not properly built

lf, after the above checks, the fault persists, call your

nearest Service Centre, indicating the fault, the

appliance model (Mod.), the product number (Prod.

No.) and the serial number (Ser. No.). This informa-

tion can be found on the rating plate located on the

right-hand side of the dishwasher door (see picture).

Prod.No. ........ Ser. No. .........

Mod. ........

RA01

PRA11GB