Zanussi ZSFN121W3 Kullanıcı Kılavuzu - Sayfa 19
Bulaşık Makinesi Zanussi ZSFN121W3 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZSFN121W3 25 sayfaları.
Ayrıca Zanussi ZSFN121W3 için: Kullanıcı Kılavuzu (25 sayfalar)
Sayfayı Yazdır
Problem and alarm code
The temperature of the water inside the
appliance is too high or malfunction of the
temperature sensor occurred.
•
The indicator
termittently.
•
The light related to the start button
flashes continuously.
Technical malfunction of the appliance.
•
The indicator
termittently.
•
The light related to the start button
flashes continuously.
The level of water inside the appliance is
too high.
•
The indicator
termittently.
•
The light related to the start button
flashes continuously.
The appliance stops and starts more
times during operation.
The programme lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
The appliance door opens during the
wash cycle.
Rattling/knocking sounds from inside the
appliance.
The appliance trips the circuit-beaker.
flashes 6 times in-
flashes 12 times in-
flashes 15 times in-
Possible cause and solution
•
Make sure that the temperature of the inlet water
does not exceed 60°C.
•
Switch the appliance off and on.
•
Switch the appliance off and on.
•
Switch the appliance off and on.
•
Make sure that the filters are clean.
•
Make sure that the outlet hose is installed at the
right height above the floor. Refer to the installation
instructions.
•
It is normal. It provides optimal cleaning results and
energy savings.
•
If the delayed start option is set, cancel the delay
setting or wait for the end of the countdown.
•
Refer to the consumption values table in the chapter
"Programmes".
•
The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
•
The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
•
Parts of the tableware are protruding from the bas-
kets.
•
The AirDry function is activated. You can deactivate
the function. Refer to "Settings".
•
The tableware is not properly arranged in the bas-
kets. Refer to basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneous-
ly all the appliances in use. Check the socket am-
perage and the capacity of the meter or turn off one
of the appliances in use.
•
Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
19