Zanussi ZBF11420SA Kullanıcı Kılavuzu - Sayfa 4
Dondurucu Zanussi ZBF11420SA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZBF11420SA 24 sayfaları. Zanussi freezer
Ayrıca Zanussi ZBF11420SA için: Kullanıcı Kılavuzu (40 sayfalar), Kullanıcı Kılavuzu (12 sayfalar)
Sayfayı Yazdır
Control panel
1
Pilot light
2
Temperature regulator
3
Quick Freeze light
4
Quick Freeze switch
5
Alarm light
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
The pilot light will light up.
Important! If the temperature inside the appliance is too
high the Alarm light will blink. Active the Quick Freeze
function.
Switching off
To turn off the appliance, turn the Temperature regulator
to the "O" position.
The pilot light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to
obtain the minimum coldness.
• turn the Temperature regulator toward higher settings
to obtain the maximum coldness.
First use
Cleaning the interior
Before using the appliance for the first time, wash the inte-
rior and all internal accessories with lukewarm water and
some neutral soap so as to remove the typical smell of a
brand-new product, then dry thoroughly.
4
1
2
3
4
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Quick Freeze function
You can activate the Quick Freeze function by pressing the
Quick Freeze switch.
The Quick Freeze light will light up.
This function stops automatically after 52 hours.
It is possible to deactivate the function at any time by
pressing Quick Freeze switch.
The Quick Freeze light will switch off.
Excessive temperature alarm
An increase in the temperature in a compartment (for ex-
ample due to an power failure) is indicated by flashing of
the Alarm light.
When normal conditions are restored the Alarm light will
switch off automatically.
Important! Do not use detergents or abrasive powders, as
these will damage the finish.
5
A medium setting is generally the most suitable.