Zanussi ZFT10210WA Kullanıcı Kılavuzu - Sayfa 10

Dondurucu Zanussi ZFT10210WA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZFT10210WA 17 sayfaları.
Ayrıca Zanussi ZFT10210WA için: Kullanıcı Kılavuzu (16 sayfalar)

Sayfayı Yazdır

Problem

Door does not open easily.

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

CLOSING THE DOOR

1. Clean the door gaskets.

INSTALLATION

WARNING! Refer to Safety chapters.

POSITIONING

Install the appliance in a dry, well ventilated indoors

where the ambient temperature corresponds to the

climate class indicated on the rating plate of the

appliance.

Climate

Ambient temperature

class

+10°C to + 32°C

+16°C to + 32°C

+16°C to + 38°C

+16°C to + 43°C

Some functional problems might occur

for some types of models when

operating outside of that range. The

correct operation can only be

guaranteed within the specified

temperature range. If you have any

doubts regarding where to install the

appliance, please turn to the vendor,

to our customer service or to the

nearest Authorised Service Centre.

Possible cause

There is no cold air circulation

in the appliance.

You attempted to re-open the

door immediately after closing.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

LEVELLING

When placing the appliance ensure that it stands

level. This can be achieved by two adjustable feet

at the bottom in front.

LOCATION

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc. Ensure that air can circulate freely

around the back of the cabinet. To ensure best

performance, if the appliance is positioned below

an overhanging wall unit, the minimum distance

between the top of the cabinet and the wall unit

must be at least 100 mm . Ideally, however, the

appliance should not be positioned below

overhanging wall units. Accurate levelling is

Solution

Make sure that there is cold air

circulation in the appliance.

Wait a few seconds between

closing and re-opening of the

door.

It must be possible to disconnect the

appliance from the mains power

supply; the plug must therefore be

easily accessible after installation.