Zanussi ZFT11100WA Kullanıcı Kılavuzu - Sayfa 10

Dondurucu Zanussi ZFT11100WA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZFT11100WA 16 sayfaları. Zanussi freezer user manual
Ayrıca Zanussi ZFT11100WA için: Kullanıcı Kılavuzu (16 sayfalar)

Sayfayı Yazdır

10 mm to allow the door to open enough so

that the shelves can be removed.

Warning!

min.

100 mm

15 mm

1. Remove the plug

from the power socket.

2. Tilt back the appli-

ance carefully so that

the compressor can-

not touch the floor.

3. Unscrew the left

foot.

Do a final check to make sure that:

• All screws are tightened.

• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Win-

ter), the gasket may not fit perfectly to the cabi-

net. In that case, wait for the natural fitting of the

gasket.

In case you do not want to carry out the above

mentioned operations, contact the nearest After

Sales Service Force. The After Sales Service

4. Remove the lower

door hinge by un-

screwing the 2 retain-

ing screws.

5. Remove the hinge

pin from the bottom of

the door.

6. Slot the hinge pin

into the hole in the

hinge plate.

7. Take the door off.

8. Refit the upper

hinge pin into the op-

posite location.

9. Fit the door in place

on the hinge pin.

It must be possible to disconnect the appliance

from the mains power supply; the plug must

therefore be easily accessible after installation.

Door reversibility

Important! To carry out the following

operations, we suggest that this be made with

another person that will keep a firm hold on the

doors of the appliance during the operations.

To change the opening direction of the door, do

these steps:

10. Slot the hinge pin

into the hole in the

hinge plate and relo-

cate the hinge assem-

bly to the opposite lo-

cation and refit using

the retaining screws.

11. Refit the bottom

hinge plate assembly

on the opposite side,

taking care that the

edge of the door is

parallel with the side of

the cabinet.

specialist will carry out the reversibility of the

doors at your cost.

Electrical Connection

Caution! Any electrical work required to

install this appliance should be carried out

by a qualified electrician or competent person.

Warning! This appliance must be earthed.

The manufacturer declines any liability

should these safety measures not be observed.

12. Remove and install

the handle (if foreseen)

on the opposite side.

13. Reposition, level

the appliance, wait for

at least four hours and

then connect it to the

power socket.