Zanussi ZFT710W Kullanıcı Kılavuzu - Sayfa 4

Dondurucu Zanussi ZFT710W için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZFT710W 16 sayfaları. Freezer
Ayrıca Zanussi ZFT710W için: Kullanıcı Kılavuzu (41 sayfalar)

Sayfayı Yazdır

• Wherever possible the back of the product

should be against a wall to avoid touching or

catching warm parts (compressor, condens-

er) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the servic-

ing of the appliance should be carried out by

a qualified electrician or competent person.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Control panel

Green Indicator Light

Red Indicator Light

Yellow Indicator Light

Freezer Switch

Temperature Regulator

Switching on

1. Allow the appliance to stand for 4 hrs after

installation.

2. Insert the plug into the wall socket.

3. Turn the Temperature Regulator clockwise

to a medium setting.

4. The Green Indicator Light will light up and

remain lit until the appliance is switched off

at the mains.

Environment Protection

ther its refrigerant circuit or insulation materials.

The appliance shall not be discarded together

with the urban refuse and rubbish. The insula-

tion foam contains flammable gases: the appli-

ance shall be disposed according to the appli-

cable regulations to obtain from your local au-

thorities. Avoid damaging the cooling unit, es-

pecially at the rear near the heat exchanger.

The materials used on this appliance marked by

the symbol

5. Press the Freezer Switch to activate the

6. The Red Indicator Light will also illuminate

This appliance does not contain gasses

which could damage the ozone layer, in ei-

are recyclable.

fast-freeze function (Yellow Indicator Light

will illuminate) and leave to run for 4 hours

to allow the correct temperature to be

reached before placing food inside.

Yellow Indicator Light lights in the switch-

ed-on state of the Freezer Switch.

until the correct temperature is reached.

A few hours after starting up the Red Indi-

cator Light will go out to show that the cor-

rect temperature has been reached for the

setting chosen and will stay out to indicate

that everything is in order. It will come on if

the freezer temperature rises unduly for in-

stance, after opening the freezer door or