Zanussi ZFT810FW Kullanıcı Kılavuzu - Sayfa 10

Dondurucu Zanussi ZFT810FW için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZFT810FW 16 sayfaları.

Zanussi ZFT810FW Kullanıcı Kılavuzu
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor, also in a garage or cellar, but
for optimum performance install this appliance
at a location where the ambient temperature
corresponds to the climate class indicated on
the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Levelling
When placing the ap-
pliance ensure that it
stands level. This can
be achieved by two
adjustable feet at the
bottom in front .
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
10
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and
the wall unit must be at least 100 mm . Ideally,
however, the appliance should not be posi-
tioned below overhanging wall units. Accurate
levelling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the side
with the hinges facing the wall, the distance be-
tween the wall and the cabinet must be at least
10 mm to allow the door to open enough so
that the shelves can be removed.
Warning!
min.
100 mm
15 mm
15 mm
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door,
do these steps:
www.zanussi.com