Zanussi ZFU216FWO Kullanıcı Kılavuzu - Sayfa 10
Dondurucu Zanussi ZFU216FWO için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZFU216FWO 40 sayfaları.
Sayfayı Yazdır
3.
Make sure that you can access the mains plug of
the appliance.
4.
Do not pull the mains cable.
5.
If the power plug socket is loose, do not insert the
power plug. There is a risk of electric shock or fire.
6.
You must not operate the appliance unless the
interior light cover
1)
•
This appliance is heavy. Care should be taken when
moving it.
•
Do not remove or touch items from the freezer
compartment if your hands are damp/wet, as this
could cause skin abrasions or frost/freezer burns.
•
Avoid prolonged exposure of the appliance to direct
sunlight.
Daily Use
•
Do not put hot objects on the plastic parts in the
appliance.
•
Do not store flammable gas and liquid in the
appliance, because they may explode.
•
Do not place food products directly against the air
outlet on the rear wall.
•
Frozen food must not be re-frozen once it has
thawed out.
•
Store pre-packed frozen food in accordance with
the frozen food manufacturer's instructions.
•
Appliance manufacturer's storage recommendations
should be strictly adhered to. Refer to relevant
instructions.
•
Do not place carbonated or fizzy drinks in the
freezer compartment as it creates pressure on the
container, which may cause it to explode, resulting
in damage to the appliance.
•
Ice lollies can cause frost burns if consumed
straight from the appliance.
Care and cleaning
Before maintenance, switch off the appliance and
disconnect the mains plug from the mains socket.
•
Do not clean the appliance with metal objects.
•
Do not use sharp objects to remove frost from the
appliance. Use a plastic scraper.
10
is in place.
2)
Installation
Important! For electrical connection carefully follow
the instructions given in specific paragraphs.
•
Unpack the appliance and check if it is damaged.
Do not connect the appliance if it is damaged.
Report possible damages immediately to the place
you bought it. In that case retain packing.
•
It is advisable to wait at least four hours before
connecting the appliance to allow the oil to flow
back in the compressor.
•
Ensure adequate air circulation around the
appliance, otherwise it could overheat. To achieve
sufficient ventilation follow the instructions relevant
to installation.
•
Wherever possible the back of the product should
be against a wall to avoid touching or catching
warm parts (compressor, condenser) to prevent
possible burn.
•
The appliance must not be located close to radiators
or cookers.
•
Make sure that the mains plug is accessible after
the installation of the appliance.
•
Connect to drinkable water supply only.
Service
•
Any electrical work required for the servicing of
the appliance should be carried out by a qualified
electrician or competent person.
•
This product must be serviced by an authorized
Service Centre, and only genuine spare parts must
be used.
Environmental Protection
This appliance does not contain gases which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance
should not be disposed of with urban refuse and
rubbish. The insulation foam contains flammable
gases: the appliance should be disposed of according
to the regulations obtained from your local authority.
Avoid damaging the cooling unit, especially at the rear
near the heat exchanger. The materials used on this
appliance marked by the symbol
1) If a light cover is included
2) If the appliance is Frost Free
3) If a water connection is included
3)
are recyclable.