Alphatron Marine BASICTRIPLEPILOT Kurulum ve Kullanım Kılavuzu - Sayfa 14

Denizcilik Ekipmanları Alphatron Marine BASICTRIPLEPILOT için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Alphatron Marine BASICTRIPLEPILOT 19 sayfaları.

Sayfayı Yazdır

5 Repair/maintenance

This chapter deals with maintenance that may be done by the owner/user. Repairs only may be

executed by a certified and authorised service engineer approved by Alphatron Marine BV. Any

deviation from this will void your warranty.

Only casual cleaning with a moist cloth is required by the owner. Make sure that water or other

fluids cannot come in contact with the (inner) hardware. Strong detergents and/or dissolvent

need to be avoided. When used with caution alcohol can be used to clean the surface of the

instruments.

Regularly check the physical status of the feedback unit near the rudder installation (look for

loose components, mounting failures and absolute free movement without obstacles). Also

check the used linkage to the rudder (either: belt with pulleys or chain or locking bars ).

The belt and pulley set we normally install are of high quality and will ensure a long life time.

At delivery no spare parts are provided with the BASICTRIPLEPILOT.

5.1

Failures:

IMPORTANT:

In case of failure during sailing on auto pilot immediate switch over to manual steering until the

pilot is repaired. Shutting down the auto pilot in such case can be done by switching the

external switch: manual steering / auto pilot steering (check chapter 3.4) into "manual"

position.

No working system after turn on, no lighted display:

Possible causes: power supply failure, check fuses, check voltage on connector strip of display

and processor unit.

Display illumination failure:

Possible causes: "dimming" is set very low. Push "dimming" button a few times to increase

brightness of lightning

No rudder movement after steering command:

Possible causes: No hydraulic pressure, or, connection between pilot box and valves is out.

External switch "manual/auto" steering could be in position "manual".

Power alarm led is on:

Possible causes: Power supply to one of 3 hardware units in de pilot set up fails. check fuses,

check voltage on connector strip of display, steering lever and processor unit.

Rudder alarm led is on:

Possible causes: Rudder/steering engine out of control > rudder moves uncontrollably,

connection between feedback and rudder hardware is broken, rudders don't move after steering

command with pilot steering lever

Manual BASICTRIPLEPILOT

BASICTRIPLEPILOT

version 1.3UK

Page 14 of 19