Discount Car Stereo A2D-CHRY Hızlı Başlangıç Kurulum Kılavuzu - Sayfa 2
Araba Stereo Sistemi Discount Car Stereo A2D-CHRY için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kurulum Kılavuzu indirin. Discount Car Stereo A2D-CHRY 5 sayfaları. Music streamiing, changer retention for select 1995-02 chrysler
PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
Careless installation and operation can result in equipment damage
Requirement
Working CD changer
Introduction
Portable audio products are everywhere, reflecting demand from active people
all over the world to take their music on the road. The A2D-CHRY module
provides Bluetooth music streaming solution for any A2DP enabled
Smartphone or Tablet for select 1995-02 Chrysler with optional CD changer. This
Bluetooth receiver allows Chrysler owners to stream audio books, apple music,
turn by turn directions and more directly into audio system and retains use of
the optional CD changer in lower dash, trunk or hatch. If vehicles does not have
a CD changer, purchase our
BLU-CHR
See Frequently Asked question at the end of this guide for more details.
Installation
Alert! Module connects directly to radio.
connected and functional.
Radio removal from dashboard required to gain access to connector. Vehicle
specific radio removal is not part of this guide; however, some may be available
upon request.
.
instead.
CD Changer (required) remains
Disconnect factory CD changer plug (See Fig.2) from radio 8-pin "CD"
1.
changer connector (See Fig. 1).
Fig. 1
Connect factory CD changer plug (See Fig. 2), to 8-pin connector on
2.
adapter (See Fig. 3)
Fig. 2
Connect 8—pin plug from adapter (See Fig. 2) to 8-pin "CD" changer
3.
connector on radio (See Fig. 1)
Connect/splice/Tap red wire (See Fig. 4) to a 12V accessory (switched)
4.
supply in vehicle. 12V accessory or switched supply is available on
radio harness.
Warning: Avoid connecting 12V accessory wire to battery (always on)
supply.
Fig. 3