3D Systems CubePro Manuel - Sayfa 10

3D Yazıcılar 3D Systems CubePro için çevrimiçi göz atın veya pdf Manuel indirin. 3D Systems CubePro 11 sayfaları. Unjamming extruder
Ayrıca 3D Systems CubePro için: Orijinal Talimat Kılavuzu (18 sayfalar), Orijinal Talimat Kılavuzu (12 sayfalar)

Sayfayı Yazdır
3D Systems CubePro Manuel
 Check jet's loom and position of thermocouple as shown:
 Install the jet back into the extruder drive. Level the jets and check the check Z gap as shown starting
on page 62 of the user guide. Disconnect head loom from the breakout board to avoid damaging the
components while levelling the jets. There will be a warning message on the screen. This can be
ignored for now. Replace the head loom connector when finished and reinstall the breakout board
using the two 2.5 mm Hex screws.
 Connect all looms back to sensor PCB and breakout board according to their markings.