Acoustic Arc DH1080 Kullanım Kılavuzu - Sayfa 4

Kulaklık Acoustic Arc DH1080 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Acoustic Arc DH1080 8 sayfaları. 2.4ghz digital wireless/wired headphone with noise cancelling

Sayfayı Yazdır

5. OPERATIONS

To start up this system and enjoy the music, please take following steps:

Turn on the audio source, plug in the 3.5mm plug of the dongle

•

with audio source

•

Turn on the dongle by pressing the Power buttons for 3 seconds.

Blue LED will light up.

•

Turn on the headphone receiver by pressing Power button for 3

seconds, LED will be Green.

•

When the audio link is established between dongle and

headphone, Blue LED on dongle flashes and headphone

become solid.

•

Turn on Noise Cancelling feature on headphone by moving the

On/Off switch on the left side to On.

•

When listening is ended, turn OFF the dongle and headphone by

pressing Power button for 3 seconds. Turn off Noise Cancelling

feature on headphone by moving the On/Off switch on the left

side to Off.

Pairing:

If the headphone remains not working after following the operation processes

above, start Pairing process by pressing the Power button for 12 seconds In the

dongle in shutdown state. After that, pressing the headphone pair button until

the blue LEDs flash. The LEDs will change to solid blue when pairing process is

finished.

NOTE:

In order to protect the dongle and save power, the dongle will automatically

switch to stand-by mode (LED will turn off) after approximately 2 minutes if there

is no audio signal, or the signal that it receives from the audio source is too

weak for proper reception. If however the signal returns to an acceptable level,

then the transmitter will automatically switch back on. The dongle will

automatically shut off if stand-by mode last for more than 15 minutes.

The headphone receiver will automatically shut off if getting no signal from

transmitter in 15 minutes.