Abbott i-STAT 1 Kullanıcı Kılavuzu - Sayfa 2

Ölçüm Cihazları Abbott i-STAT 1 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Abbott i-STAT 1 9 sayfaları. For use with a clia certificate of waiver
Ayrıca Abbott i-STAT 1 için: Hızlı Referans Kılavuzu (7 sayfalar)

Sayfayı Yazdır

System Components

i-STAT 1 Analyzer

Downloader

Downloader/Recharger

For in vitro diagnostic use.

See System Manual for instructions.

Intended Use: The i-STAT 1 Analyzer is intended for use with i-STAT cartridges

for the in vitro quantiﬁcation of various analytes in whole blood.

i-STAT Cartridges

Electronic

Simulator

i-STAT 1

i-STAT Printer

Martel Printer

Quality Check Messages and Codes

Message

Cause

Date Invalid,

Date outside six

Check Clock

month lifetime of

software.

Dead Batteries,

Insufﬁcient power to

Replace Batteries

complete a test cycle.

Temperature Out of

Temperature outside

Range, Check

operating range of 16

Status page

to 30 °C.

Invalid or Expired

Software expired or

CLEW

corrupt.

Analyzer Interrupted,

Last cartridge run not

Use Another

completed.

Cartridge

Cartridge Error

Usually problem with

sample or cartridge

ﬁlling.

Cartridge Preburst

Calibrant pack burst

before cartridge inserted

into handheld.

Unable to Position

Cartridge not sealed.

Sample

Clot in sample.

Aberrant cartridge.

Sample Positioned

Cartridge underﬁlled.

Short of Fill Mark

Sample Positioned

Cartridge overﬁlled.

Beyond Fill Mark

Test Cancelled by

User did not respond

Operator

to mandatory prompt

before handheld time

out.

Cartridge Type Not

Software does not

Recognized

recognize cartridge.

Action

Select 5-Clock Set from

Administration Menu. (Password

protected.)

Replace disposable batteries or

recharge the rechargeable battery.

Check handheld temperature by

pressing 1 for Analyzer Status under

the Administration Menu. Move

handheld to warmer area if below

operating range or to cooler area if

above the range.

Verify that the handheld's date is

correct. Change software if expired.

Update again if not expired.

Check the battery pack inserted

properly. Check for Low Battery

startup warning.

Use another cartridge. If same code

repeats more than twice, try another

handheld.

Use another cartridge - do not press

on center of cartridge. Check that

cartridges have not been frozen.

Use another cartridge.

Use another cartridge - ﬁll to Fill

Mark.

Use another cartridge - do not ﬁll

beyond Fill Mark.

No action required.

Update software. Check to see if

cartridges are expired.