Aerial AP 50 Kullanım Kılavuzu - Sayfa 11

Kurutucu Aerial AP 50 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Aerial AP 50 17 sayfaları. Swimming pool dehumidifier
Ayrıca Aerial AP 50 için: Kullanım Kılavuzu ve Garanti (14 sayfalar)

Sayfayı Yazdır

6.5 Add fresh air (option)

The series AP is fitted with an aperture for additional air. (Figure 5.1 - Pos. 7)

Ø With the help of a flange D= 100 mm (optional accessories, article no. 6109-

0020) fresh air can be added over this opening. In addition an appropriate wall

opening (D = 80 mm) is to be created behind the equipment, over which fresh

air will then be sucked from outside

6.6 Putting into operation

Ø After a transport and the installation the dryer should rest in it´s final position for

approx 15 minutes. During this period of time, the oil inside the refrigerating

system, that was foamed during transport will return into the compressor. We

recommend this procedure since it extends the service life of the compressor.

Ø If the dryer has been installed correct, it should start automatically with hygrostat

in Pos. I and On-/Off-switch in pos. I (figure 5.3). First the compressor starts and

after a while the fan will also start. This function is to avoid to high starting

current.

6.7 Hygrostat control

The air dryers of the AP-series dispose of a hygrostat for setting the required

humidity value. This hygrostat is located in the operation panel. It makes that the air

dryer cuts in as soon as the ambient humidity exceeds the preset value. If the

humidity value falls below the set value, the hygrostat will switch off the unit.

Pos. 0

= Switched off

Pos. 1

= Continues working

80-100% = The dehumidifier switches off

when a humidity of approx. 80-

95% r.h. has achieved. And

switches on again when humidity

is higher than 80 - 95%.

60 - 80% = The dehumidifier switches off

when a humidity of approx. 60-

80% r.h. has achieved. And

switches on again when humidity is higher than 60 - 80%.

40 - 60% = The dehumidifier switches off when a humidity of approx. 40 - 60% r.h.

has achieved. And switches on again when humidity is higher than 60 –

60% r.h.

20 - 40% = The dehumidifier switches off when a humidity of approx. 20- 40% r.h.

has achieved. And switches on again when humidity is higher than 20 –

40% r.h.

The smooth setting option of the hygrostat makes a very convenient humidity

control possible for you. If very precise values are requested, you should match the

hygrostat with the information on a precise hygrometer.

page 11 of 17