3DUpFitters CR-10 Smart Enclosure Kit Kurulum Kılavuzu - Sayfa 14

3D Yazıcılar 3DUpFitters CR-10 Smart Enclosure Kit için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3DUpFitters CR-10 Smart Enclosure Kit 19 sayfaları.

Sayfayı Yazdır

You can now attach the actual display to the 3-

pronged display mount. It can be a little tricky

to seat because of the manufacturer's design,

but after trying it 20 times, here's a good

approach:

1. Situate the display so that the 3 prongs ﬁt

inside the 3 holes and wiggle the display

until it is ﬂush against the mount.

2. Slide the display down along the amount a

fraction of a mm to seat the prongs into place.

8. Attach Front Tray

The front tray exists to give the fans inside the printer a source of cool air. With the fan

in back running this gives a clear path to bring air into the enclosure, cooling the

electronics, and then out the back.

Just slide in the tray from the outside and use the M4 12mm screws to attach it to the

front. The lid ﬁts into place covering the gap between the printer and the front of the

enclosure.