dji Matrice 200 Series V2 Hızlı Başlangıç Kılavuzu - Sayfa 7
Dronlar dji Matrice 200 Series V2 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. dji Matrice 200 Series V2 15 sayfaları. Manifold 2 mounting bracket
Ayrıca dji Matrice 200 Series V2 için: Hızlı Başlangıç Kılavuzu (7 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Ürün Bilgileri (8 sayfalar)
Sayfayı Yazdır
5. Flight
Power on the remote controller,
Toggle the Flight
Mode switch to
monitor, and aircraft.
P-mode, the safest
flight mode.
After the monitor is powered on, wait for a pop-up window that asks for a selection of USB device use, and then select "DJI Pilot". Otherwise, the app cannot be
connected to the remote controller.
Always set an appropriate RTH altitude before takeoff. Please refer to the Disclaimer and Safety Guidelines for more details.
Manual Takeoff
OR
Combination Stick Command to start/stop the motors
Return-to-Home
Press and hold to initiate the RTH procedure. Press again to cancel.
Rotating propellers can be dangerous. DO NOT start the motors in narrow
spaces or when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still
spinning.
After landing, power off the aircraft before turning off the remote controller.
It is important to understand basic flight guidelines for the safety
of both you and those around you.
Refer to the Disclaimer and Safety Guidelines for more
information.
DJI Pilot
Ready to Go (GPS)
App
Before taking off, ensure that the Aircraft Status Bar in the
DJI Pilot app reads 'Ready to Go (GPS)' or 'Ready to Go
Launch the DJI
(Vision)' if flying indoors.
Pilot app.
Left stick up
(slowly) to take off
Manual Landing
Pull left stick down
(slowly) until you touch
the ground.
Hold for a few seconds
to stop the motors.
To stop the motors mid-flight, press
the RTH button while simultaneously
pulling the left stick to the bottom
inner corner. Stop motors mid-
flight will cause the aircraft to crash.
The motor can only be stopped
mid-flight when the flight controller
detects critical error.
GEO Zones
Learn more:
http://flysafe.dji.com/no-fly
7