Artila Matrix-512 Kullanıcı Kılavuzu - Sayfa 7

Endüstriyel PC Artila Matrix-512 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Artila Matrix-512 17 sayfaları. Linux arm9 industry box computer

Sayfayı Yazdır

3. Pin Assignment and Definition

3.1 Reset Button

Press the "Reset" button to activate the hardware reset. You should only use this function if the

software does not function properly.

3.2 Power LED

The Power LED will show solid green if power is properly applied.

3.3 Ready LED

The Ready LED will show solid green if Matrix-512 complete system boot up. If Ready LED is off

during system boot up, please check if power input is correct. Turn off the power and restart

Matrix-512 again. If Ready LED is still off, please contact the manufacture for technical support.

3.4 Link / Act LED

When Ethernet port are connected to the network, Link/Act will show solid green and if there is traffic is

the Ethernet port, this LED will flash.

3.5 Serial Port LED

These four dual color LEDs indicate the data traffic at the serial ports. When RxD line is high then

Green light is ON and when TxD line is high, Yellow light is ON.

3.6 Ethernet Port

3.7 Serial Port

The four serial ports are 3-in-one RS-232/422/485 ports and the interface is configured in by software.

Please refer to example program to configure the serial or use "setuart" utility to configure serial port

setting. RS-485 hardware supports data direction control. Therefore it is software compatible with a

RS-232 interface.

Pin No.

Signal

ETx+

ETx-

ERx+

ERx-

‧3‧

Matrix-512 User Guide