Artis BE810M Kullanıcı Kılavuzu

Kulaklık Artis BE810M için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Artis BE810M 2 sayfaları. Bt earbuds

Sayfayı Yazdır
Artis BE810M Kullanıcı Kılavuzu
BE810M
BT Earbuds
Music & Calls Wirefree!
U S E R M A N U A L
• BT transmission range can reach above 10m when there is no barrier or
interference (the range may be slightly varied for different mobile phones)
• Receiving sensitivity: -85dBm
• Battery capacity: 50mAh for both left and right headsets
• Charging: the special charging case is equipped, which has 300mAh battery
capacity.
• After the headsets are fully charged, the time for listening to music or making
calls with single headset is 5h and with both headsets is 2.5h (the use time
may be slightly varied depending on the volume and device).
• Standby time: when using single headset: 120h, when using both headsets: 60h
• The headsets will show red light when being charged in the charging case, and
will show blue light at full charge. The headsets are neither being charged nor
discharging at full charge.
• Charging time: About 1-2h for both headsets to be fully charged
• It takes about 2h for the charging case to be fully charged, with red light as
charging indicator
• The mobile phone will display the headset battery status and the headset will
show the blue discharging indicator light, after the headset is successfully
connected to the mobile phone
• Using CVC6.0 noise cancelling technology
• Caller ID reporting and voice prompt supported
• Support: a2dp\avctp\avdtp\avrcp\hfp\spp\smp\
att\gap\gatt\rfcomm\sdp\12cap profile
Website: www.artis.in | www.artisstore.com
Customer care: +91-20-26113250/60
Attention Notice :
• Please properly control the volume and time when using the headset.
• To ensure the safety, please do not use the headset in a potentially
dangerous environment.
• Try to avoid listening to music, making or answering a call while driving,
because the distraction may lead to danger.
• Please keep the headset away from children, to avoid danger due to
improper use by them.
• Avoid water from entering the headset during grooming, to avoid damage
of the headset or sound quality.
• Try to avoid turning the volume so high that you cannot hear anything
around you. please adjust to an appropriate volume if you have tinnitus or
the volume is too high.
• Please immediately stop using the headset when feeling obvious
discomfort, irritation or other adverse reactions during using it.
• Avoid storing or using the headset in an environment with temperature
lower than -15°C (5°F ) or higher than 55°C (131°F); otherwise, this may
shorten the life of headset or battery.
Earphone Overview:
Headset
charging pin
Headset charging
Headset charging indicator
contact point
USB charging
Microphone
interface
Indicator
charging indicator
Multi functional Key
Headset charging switch
Headset use :
Insert the headset into
Rotate the headset to apply
the ear as shown
it to the ear canal.
Charging and Battery:
1. Please turn off the headset before charging.
2. Insert the USB charging cable into the Micro USB charging interface of the
charging case, with the other USB end into a USB charger or other charging
device. And the charging case will start to be charged, with the red light
normally on during the charging. The red light will disappear when the case is
fully charged.
3. Put the left and right headsets into the charging case, close the upper cover of
the charging case, press the switch at the bottom of the charging case, and the
headsets in the charging case will show red light. About 2h later, at full charge,
the red light will be off and blue light will be normally on.
Warning:
These headsets and charging case use the built-in rechargeable battery that is
non-removable. Do not attempt to remove the battery from the headset and
charging case, otherwise, it may damage them.
How To Pair The Earphone:
1. Separately Using the Left and Right Headsets Turning On:
• Long press the Multifunction key until the blue light is on and the headset
makes an audio prompt.