AluTeam BR 13x-3 Montaj Talimatları Kılavuzu - Sayfa 3

Kamyonlar AluTeam BR 13x-3 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. AluTeam BR 13x-3 14 sayfaları. Box kits

Sayfayı Yazdır
Falling
Suspended loads
objects
on the crane
Hazard from
Hazardous
substances
high-pressure
cleaners
Fig. 132
Assembly instructions BR 133-3 to 139-3
•
Excessive torque
•
•
Fig. 122

1.3 Safety instructions

Pay attention to your own safety and to that of your employees.
Working with kits involves hazards. Therefore caution is always advised,
in particular you should absolutely:
Tumbling parts or
module assemblies
... Use a lifting beam when unloading or transporting of the packed kit
... Secure the kit against inclination, tilting and toppling over when
... Only place transportation frames onto flat surfaces, and secure them
Risk of scalding
... Always wear a helmet during crane work and only lift module assem-
Fig. 131
... Remove all the packaging straps at the time of installation in the
1
... In case of utilisation of an assembly carriage, secure it against
... Provided that you raise the floor over the airline rails, using a mini-
... Only lift the roof with a lifting beam or vacuum suction-unit! The mount-
Fig. 133
2
... Comply with the legal specifications, such as StVZO, BGV D 29, BGV
... For cleaning and sealing work, make sure there is sufficient aeration
Fig. 134

1.4 Copyright

The copyright of these instructions belongs to AluTeam.
They are only intended for the professional assembly company and its
staff and, either in total or in parts, may not be:
Contraventions can have civil and criminal legal consequences!
Fig. 14
Status 03/2022
The seating faces of the module assemblies must be free from
contamination and dirt.
Never apply screws diagonally, they must not tilt.
ques
(2.3). Undershooting weakens the strength of the system, a
clear overshooting can lead to damage to component parts!
Connect the component parts directly with the supplied screws.
They may be used one-time only. External or used screws endanger
Always use new AluTeam screws
operational safety.
with a crane.
unloading/transporting the packed kit with a forklift.
against inclination, tilting and toppling over (Fig. 132).
blies vertically and not at an angle. Never step under raised loads.
The suspension in the crane must always be above the centre of
gravity of the assembly.
specified sequence, and remove the white packing straps first. The
individual components or groups are attached with a red packing
strap. Secure the part to be taken out against tipping over before
cutting the packing strap (Fig. 133/134).
rolling away.
mum of 2 double-stud fittings for that with sufficient load-bearing
capacity.
ing brackets (airline rails) are used for this purpose only as an assembly
aid. Assembled boxes may not be lifted with them.
A1, BGG 915, BGG 916. This is the responsibility of the vehicle manu
facturer.
and ventilation, and observe the processing specifications and the
safety and disposal regulations of the adhesive/ sealant manu-
facturer. Please request the safety sheet and the processing
specifications from the manufacturer printed on the cartridge or under
+49 (0)521 4173-1110.
•
reproduced
•
disseminated or
•
disclosed in any other way.
Former instructions lose their validity.
Consider the tor-
also for repairs.
Risk of pulling out!
3 / 14