Artsound MAT-8000 Kullanım Kılavuzu - Sayfa 5

Müzik Mikseri Artsound MAT-8000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Artsound MAT-8000 16 sayfaları. Venue mixer

Sayfayı Yazdır

2. Introduction.

The MAT-8000 is an 8 channel model which is cater for multi-zone, paging and multi-sources selection system.

It is a complete solution for multi-zone, multi-functional venues like entertainment places, large hotels, sport or gym

centers, shopping malls, etc.

MAT-8000 offers direct connection of up 8 music source inputs ,8 remote control panels, 4 remote paging consoles and

one microphone input,all of these inputs can be freely allocated into different 8 zone outputs simultaneously.

3. Front panel layout.

Select Source

Zone LED Display

Monitor Zone Select

Page Busy

MIC Priority Indicator

MIC Priority Button

Music Volume

Master Volume

1. SOURCE SELECT

The source select button (1) is used to select the source

for the zone. Each zone has a separate source selection

button. There are 9 selectable sources: Line sources

1 through 8 and a local Microphone source.

A different local source (remote in wall mixer or source

select/volume control) can be connected to each zone. A

zone cannot select the local source connected to another

zone. Pressing the source select button will cycle through

all zones in sequence:1, 2, 3, 4, 5, 6,7, 8, L and OFF.

To select a required source, press the source select but-

ton (1). Once the display shows the desired source, press

in sequence:1, 2, 3, 4, 5, 6,7, 8, L,and OFF. To select a

required source, press the source select button and the

ENTER (14) button to confirm the change to the selected

source.

Note:

The source will only change after the ENTER (14) button

is pressed. If the ENTER(14) button is not pressed, the

source selection will return to previous setting after 10

seconds. When the system is used in conjunction with

remote control panels, the zone source select button will

be disabled when a remote control panel is connected

MIC Volume

10. Monitor LED Display

11. Monitor Zone Output Level

12. Monitor Volume

13. ESC

14. ENTER

15. BGM ALL

16. Page ALL

to a zone. In this situation the source selection can only

be controlled via the remote control panel. If the event

power is lost, the last source selection settings are auto-

matically saved and the unit will return to its previously

configured source selections when powered back on.

2. ZONE LED DISpLAy

The Single Digit Zone LED Display will display the select-

ed source number: lines 1-8 and local input shown as L.

3. pAgE BUSy

The Zone Page Busy indicator LED (3) will illuminate

amber to indicate a paging microphone is paging to this

zone.

4. MIC1 pRIORITy INDICATOR

The MIC1 Priority Indicator LED (4) will illuminate blue

indicating the Zone MIC1 priority paging function is ena-

bled.

5. MIC1 pRIORITy BUTTON

The MIC1 Priority button (5) will enable/disable the MIC1

priority paging function.When enabled MIC1 will override

zones 1-8 and all local inputs, if a signal is present on

MAT-8000