Akron DECKMASTER 3440 Kurulum, Çalıştırma ve Bakım Talimatları - Sayfa 3
Monitör Akron DECKMASTER 3440 için çevrimiçi göz atın veya pdf Kurulum, Çalıştırma ve Bakım Talimatları indirin. Akron DECKMASTER 3440 15 sayfaları. Electric monitor for standard configuration with potentiometers & u2 logic box
Sayfayı YazdırDo not install shutoffs on the outlet of the monitor. Shutoffs increase the potential for pressure surges
due to water hammer, which have the potential to cause an injury or damage the monitor.
Disconnect power and disable flow before maintenance.
Keep all personnel out of the Danger Zone, in front of the outlet of the monitor when the water source
is attached. Dangerous flow velocities can cause serious injury.
Ensure the thread on the nozzle swivel matches the thread on the monitor outlet. Do not
over-tighten the nozzle onto the unit.
Insufficient structural support at the inlet flange can lead to failure, which has potential to cause
an injury.
Not designed for explosive environments
The monitor contains moving parts. Keep hands, fingers and objects away from pinch points.
Operating the monitor without the permanent travel limit stops in place could cause damage to the
monitor and could potentially injure the operator.
Ensure that the monitor is returned to the Stow position after use.
If not equipped with an automatic drain valve, drain the monitor after use to prevent freeze damage.
The monitor, nozzle, logic box, control box, tether controller and field adjustable stops are made for
optimal performance. Do not alter in any manner.
The monitor was designed for use with the 5177Akromatic, 1577 SaberMaster or 2499 Stack Tip
nozzles. Use of any other nozzle could affect the speed or operation of the unit and should be tested
before being put into service.
Replace the identification tags if they should become worn or damaged.
Not recommended for use in salt water applications
Not recommended to mount onto a raised flange. This may cause damage to the monitor's flange
when tightening bolts.
Use a nozzle of the same material as the monitor to eliminate the effects of galvanic corrosion.
Mechanical Installation Instructions
The monitor is to be mounted on a waterway which is capable of withstanding the pressure applied to the monitor as
well as the reaction force and resulting bending moment of the nozzle (934 lbs. at 200 PSI and 1250 GPM).
Use the operating windows of figures 1a or 1b to determine the mounting area required.
Page 3