ASI VELARE 0663-2 Kurulum Kılavuzu - Sayfa 2

Banyo Armatürleri ASI VELARE 0663-2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. ASI VELARE 0663-2 3 sayfaları. Btm system cabinet

VELARE™ BTM SYSTEM CABINET INSTALLATION GUIDE (PAGE 2 OF 3)
INSTALLATION OF EL-LIGHTING
Connect the two (2) output connector plugs of the 12V AC/DC Adapter with 2 Outputs (provided) into the two
(2) DC Power switches' sockets (provided) located at the top of the cabinet.
Connect the 12V AC/DC Adapter (provided) to the Quad Outlet (by others).
Turn ON the two (2) DC switches (provided).
INSTALLATION OF HAND DRYER
Electrical service is supplied and connected by others. The power wiring should go through the KO located at the
Hand Dryer Bracket. Refer to 0196-OM for power wiring installation. Hand Dryer Cover can be removed by
removing the two (2) black plastic hole caps located at the bottom of the cabinet to access the cover security
screws with the security hex key provided with the 0196 dryer.
INSTALLATION OF FOAM SOAP DISPENSER
Foam Soap Dispenser includes power supply adapter (provided, item 1) to be connected into one of the quad
outlets (by others).
Soap Tank can be filled by removing the soap tank from soap tank holder bracket and unscrewing the cap.
Fill the tank with foaming soaps with a pH in range 7±1.5 and viscosity in range 1 ~ 100 cP (mPa•s).
Close the cap after filling and place the soap tank back to the soap tank holder bracket. Make sure the soap tube
reaches to approximately 1/4" [6] above the bottom of the soap tank through the guide sleeve and it is not bent or
curved.
Refer to OM provided with specific soap dispenser for maintenance instructions.
FIG. 3
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
MODEL №:
ISSUED:
REVISED:
FIG. 4
0663-1/2
29 JAN 2019
13 MAR 2019