Asko 1805 FI Kurulum Talimatları Kılavuzu - Sayfa 4

Bulaşık Makinesi Asko 1805 FI için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Asko 1805 FI 12 sayfaları.

Sayfayı Yazdır

Asko 1805 FI Kurulum Talimatları Kılavuzu

CORNER INST

CORNER INSTALLA

ALLA

ALLATION

ALLA

If the dishwasher is installed in a corner, there must be

a minimum clearance of 2 inches (50 mm) from the

side wall so the door can open.

HOT T T T T W W W W W A A A A A TER SUPPL

TER SUPPL

TER SUPPLY Y Y Y Y

TER SUPPL

WARNING! Plumbing connections must comply with

applicable sanitary, safety and plumbing codes in your

area.

The machine should preferably be connected to a hot

water supply. If a cold water supply is used, the washing

times will be longer but the performance will not be

affected.

The hot water supply line should be minimum 3/8" OD

copper tubing. The inlet valve has a 3/8" NPT female

connection.

CONNECTIONS

Compression nut

Inlet valve, 3/8" OD

90° street elbow

Page 4

TION

Compression sleeve

3/8" OD copper

water line

90° compression elbow

3/8" NPT one end

2" clearance

After determining where the water supply line will enter

the dishwasher, drill a 1" access hole and run the line

to the approximate inlet valve location shown in the figure

below. The inlet valve is on the right front of the machine,

so the water line should be placed on the right side.

If you use soft copper line, leave the tube straight out in

the opening to slide the dishwasher in. Bend the tube

into position after the dishwasher is slid into the cabinet

opening.

For service convenience, a shut-off valve (not supplied)

should be installed in the supply line in an easily

accessible location (such as, beneath the sink) or in

the supply line near the dishwasher fill valve.

It is important that the water supply line and the shut-off

valve have a sufficient flow volume. At last 3 gallons (12

liters) per minute must be able to pass through the

line. The water pressure should be 18-176 psi.

WARNING!

In order to prevent heat damage to the inlet valve, all

solder connections must be made before the water

line is connected to the dishwasher.

INST

INSTALLA

INST

ALLATION

ALLA

(1) Hot water supply

(2) Shut-off valve

(not supplied)

NOTE:

You should only install the number 4 tubing

before you push the machine into position.

Tubing number 5 is to be fitted when the

machine is in position.

TION

(3) Alternate locations

(4) & (5) Tubing