Asko D5223XXLCS Kurulum Talimatları Kılavuzu - Sayfa 8
Bulaşık Makinesi Asko D5223XXLCS için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Asko D5223XXLCS 16 sayfaları. Xxl dishwasher
Ayrıca Asko D5223XXLCS için: Planlama ve Tasarım Kılavuzu (3 sayfalar)
Sayfayı Yazdır
DRAIN CONNECTIONS
ASKO provides a 7/8" (22 mm) diameter corrugated drain
hose which is connected to the back of the unit to form
a high loop. If additional drain hose is needed, please
purchase an ASKO drain hose extension kit with a 7/8"
(22mm) copper tube.
NOTE:
Do not use any fittings anywhere in the drain
line that are less than 7/8" (22 mm) ID.
The access hole for the drain line should be 1-5/8" (41 mm)-
2" (50mm) max.
The end of the drain line
is 1/2" (12 mm), but it is
adjustable to 7/8", 3/4",
5 / 8 " ( 2 2 m m , 1 9 m m ,
and 16 mm). If the drain connection is larger than
1/2" (12 mm), you can easily cut the drain line to fit the
connection.
The illustrations to the right show three ways to connect
the drain supply line.
THE HIGH LOOP
The high loop is necessary for
proper draining. Therefore, all ASKO
dishwashers have the drain hoses
attached to the drain pump and
fastened to the top back of the unit, as
illustrated. This gives the drain hose an automatic high
loop, which is necessary for proper draining. The drain
hose is fastened at the best high loop height.
To eliminate potential drain problems, simply leave
this hose in place.
DO NOT REMOVE THE HIGH LOOP!
IMPORTANT THINGS TO REMEMBER:
♦ Failure to provide the proper drain connection height
(minimum of 20" (508 mm) above the bottom of the
dishwasher base) or a 20" (508 mm) high loop will
result in improper drainage, which will damage the
machine.
♦ No part of the drain hose should be higher than 35"
(889 mm) from the bottom of the dishwasher.
♦ The drain hose can be extended to a maximum length
of 10 feet (3048 mm). Joints and jointed tubes, if any,
must have a minimum 5/8" (16 mm) ID.
♦ If the drain line is going to be connected to a waste
disposer, be sure to remove the knockout or plug
from the fitting on the disposer before connecting
the drain line.
♦ Do not use fittings smaller than 5/8" (16 mm);
otherwise the water may not drain properly.
When the installation is ready, open the supply valve
and let the pressure act for a while. Then check that all
connections are tight and there are no leaks.
THREE WAYS TO INSTALL
DRAIN CONNECTIONS
A) Typical connection to sink plumbing before
trap (high loop drain)
B) Connection to air gap then to the trap
C) Connection to waste disposer with air gap
NOTE:
Don't forget to remove the knockout or plug from the
disposer fitting.
Customer Care Center
1-800-898-1879
www.askousa.com
508
508
508
Page 8