AMCOL 3500-ETC Технічний опис - Сторінка 6
Переглянути онлайн або завантажити pdf Технічний опис для Контролер AMCOL 3500-ETC. AMCOL 3500-ETC 8 сторінок. Electronic timing controller
Також для AMCOL 3500-ETC: Посібник оператора (12 сторінок)
Друкувати сторінку4 System in Detail
The 3500-ETC has two operating modes: automatic and
manual.
Automatic mode uses a control signal from the PLC or
machine output to operate the system. Manual mode
allows for temporary operation without an electrical
connection for setup, maintenance, and
troubleshooting. When the system is not operating, it will
remain in idle/ready until activated.
Both the system status and the current cycle time are displayed directly on an
LCD screen on the PLC inside the ETC. The ETC includes lighted solenoid caps,
allowing for easy visual confirmation that the solenoids on the 3500 are
operating correctly.
This controller is made to operate with standard AMCOL 3500E Electrostatic
Powder Coating Systems. For more information about the 3500E, see the AMCOL
3500E Electrostatic Powder Dispensing System Technical Description.
3500-ETC Technical Description
Pressing the right button navigates to
different screens where system cycle
timings can be modified. Pressing the
up or down buttons on these screens
will increase or decrease the Fluidizing
Air and Spray On settings 100ms
increments, and the Dust Collector
timing in 1s increments.
P a g e |5