AeroBound AB01 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари AeroBound AB01. AeroBound AB01 11 сторінок.

Друкувати сторінку

MONITOR ASSEMBLY INSTRUCTIONS

HALF LOGO WIDTH

Product logo

(A)

Fix the sensor to the central foot under

the handlebar, by loosening the screw

on the monitor holder enough to slide

25% Cyan

45% Cyan

75% Cyan

35% Black

0% Magenta

60% Yellow

100%Yellow

0% Black

it over the foot. The sensor should be

approx. 2mm from the mat for the

most accurate readings.Tighten the

screw so it stays in place.

Place the battery into the back of the

monitor making sure that it is placed

the correct way round, as shown in the

battery well.

Slide the monitor attachment into the

back of the monitor and place onto

the sensor.

Connect the wire from the monitor to

the wire on the sensor.

RESISTANCE BAND INSTRUCTIONS

To attach the resistance bands,

remove the rubber feet from the two

side feet of the AeroBound, open up

the loop on the resistance band and

slide over the foot before attaching

the rubber foot back on.

MONITOR INSTRUCTIONS

COUNT:

Shows the amount of jumps

performed.

TIME:

Shows the length of time

exercising.

CAL:

Shows the amount of calories

burnt during exercise.

STRD/MIN:

Shows the amount of

jumps per minute you are performing.

SCAN:

Cycles through each mode

after a few seconds.

RESET:

Will clear any information

displayed on the monitor. Press this at

the start of each session.

MODE:

Allows you to cycle through

the different display functions.

The monitor requires one AAA battery

(not supplied). Remove battery when

not in daily use.

Dispose of old batteries safely.

The readings from the display

monitor may vary and are to be

used only as a guide