AerobTec Altis Micro Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади AerobTec Altis Micro. AerobTec Altis Micro 17 сторінок. Recording / competition altimeter with telemetry

Друкувати сторінку

Fig 3: Connection scheme for competition use (ESC - electronic speed controller, THRO -

throttle receiver channel)

If you use a separate power source for your receiver or a battery eliminator circuit (BEC), you should

make sure to separate your power supply from your ESC and the Altis Micro. This is done by

disconnecting the red wire from the ESC connector. This is not usually necessary for "Opto" ESCs. The

disconnected red wire must be insulated to ensure that it does not cause any short circuit or other

problems. See Fig 4.

Fig 4: Connection of Altis Micro with BEC

Some radio systems provide telemetry functions. These functions allow wireless transmission of certain

data from the aircraft during the flight and display it on your Tx or monitor screen. The Altis Micro has

COM connector reserved for this purpose. Use a Molex/JR telemetry cable (sold separately) to connect

your Altis Micro to the telemetry input of your receiver. The schematic in Fig 5. shows the direct connection

of Jeti model Ex, Multiplex MSB and Graupner Hott. Some other brands are supported using

Telemetry

Converter FF

Telemetry Converter

HS.

AerobTec Altis Micro User Manual