AMERITRON AL-82 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підсилювач AMERITRON AL-82. AMERITRON AL-82 16 сторінок. Full power
Також для AMERITRON AL-82: Інструкція з експлуатації (16 сторінок)

Друкувати сторінку

TRANSFORMER INSTALLATION

For 220V connections(see Fig. 3), follow the first three

steps on the 240V operation on page 4, then follow the

steps below:

1. Slide the RED boot back on the BRN/WHT

wire

2. Clip the terminal connector off the wire and

slide the RED boot off.

3. Remove the restraint from the GRN wire and

slide the RED boot on to the wire.

4. Solder the terminal connector to the GRN wire.

5. Tape up the BRN/WHT wire because it will not

be used.

Install the tubes, chimneys, anode. bracket and plate cap

connectors as follows: (see Fig. 4)

1. After removing the packing material from

around the anode connectors, install the 3-

500z tubes. NOTE: One of the tube pins is

offset. This offset pin "keys" the tube base

and socket. Install the tube by aligning the

tube pins with the socket contact terminals,

then seat the tube with vertical pressure ON-

LY. Do not "rock" or "twist" the tube.

TUBE INSTALLATON

Fig. 4 Top View of 3-500z tubes

Fig.

2. Place the chimneys over the tubes and seat with

the metal clips inside each chimney. Do not

apply excessive force or the glass chimney

may crack.

3. Attach the blocking capacitors to the anode

bracket and secure with the two 6/32 screws.

4. install the plate cap connectors on the tubes in

the positions shown. Be careful not to drop

any hardware inside the chassis.