Doorentryonline DT595A Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для За замками Doorentryonline DT595A. Doorentryonline DT595A 9 сторінок. 2-wire audio entry system

Друкувати сторінку

DIP Switch Settings

The DIP switch is designed to set the code for door panel and monitor, there are two states for
each DIP switch, please refer to the following:
ON(1)
O N
=
Door panel DIP setting
Total of 3 bits can be configured, bit-1 and bit-2 are used to assign the ID code for the door panel, bit-3
is used to match the video impedance.The switches can be modified either before or after installation.
Bit state
ON
1 2
3
ON
1 2
3
ON
1 2
3
ON
1 2
3
Note: if the video impedance needs to be matched, please set the bit-3 on.
Indoor monitor DIP setting
There are 6 bits in total. The DIP switches are used to configure the user code for Monitors.
Bit-6 is an video impedance match switch, which have to be set to ON if match the impedance,
otherwise set to OFF.
Bit-1~Bit-5 are used to set the user code to the door panel, the user code should set from 0-15.
Please refer to the following settings:
OFF(0)
O N
=
Description
ID = 0(00), set for the first door panel
ID = 1(10), set for the second door panel
ID = 2(01), set for the third door panel
ID = 3(11), set for the fourth door panel
-8-