ASTRO-MED Dash 8Xe Посібник із швидкого старту - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Реєстратори даних ASTRO-MED Dash 8Xe. ASTRO-MED Dash 8Xe 15 сторінок. Data acquisition recorder

Друкувати сторінку

Enter Scale

When the power switch is set to the off position or if AC power is lost or removed, the Dash 8Xe / Dash 8X begins the

power down sequence. This is indicated by the green LED next to the power switch that will be on while the power down

sequence occurs. Note that the LED will either be a solid green or it may flicker. It is very important not to turn the power

switch back to the on position during the power down stage. The Dash 8Xe / Dash 8X must be allowed to complete the

power down sequence to insure proper operation.

This completes the Dash 8Xe / Dash 8X Quick Start Guide. Please note that the Dash 8Xe / Dash 8X has much more

capability than presented in this guide. Please see the Operations Manual for details. Should you require additional

assistance, you can contact our Technical Support Department toll-free at 877-867-9783 or by e-mail:

[email protected]

Under the Engineering Units box on the User Unit Setup – Waveform 1 window there is a

section named Scale. Now that you have entered AMPS, you can now enter either

AMPS/Volts or Volts/AMPS.

Since our probe has a 10mV/A output, we will enter 0.01 into the Volts / AMPS box.

Press the Volts / AMPS box and enter 0.01 into the Scale keypad.

Press OK on the Scale keypad.

Press OK on the User Unit Setup – Waveform 1 screen.

Press OK on the Amplifier Channel Settings (Analog Channel Setup) window.

Waveform (Channel) 1 is now set to measure current using a 10mV/A current probe.

User Unit Setup – Waveform 1

This concludes the engineering units example.