Asus A7V-VM Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Материнська плата Asus A7V-VM. Asus A7V-VM 23 сторінки. Athlon/duron microatx motherboard
Також для Asus A7V-VM: Посібник із швидкого старту (22 сторінок)
Друкувати сторінку
- 1. Specifications
- 2. Hardware Setup
- 3. Layout Contents
- 4. Hardware Setup Procedure
- 5. Motherboard Settings
- 6. System Memory (DIMM)
- 7. General DIMM Notes
- 8. DIMM Memory Installation
- 9. Central Processing Unit (CPU)
- 10. Expansion Card Installation Procedure
- 11. Expansion Cards
- 12. Assigning Irqs for Expansion Cards
- 13. Standard Interrupt Assignments
- 14. Interrupt Request Table for this Motherboard
- 15. Accelerated Graphics Port
- 16. External Connectors
2. HARDWARE SETUP
8) Audio Port Connectors (Three 1/8" GAME_AUDIO)
Line Out can be connected to headphones or preferably powered speakers. Line
In allows tape players or other audio sources to be recorded by your computer
or played through the Line Out. Mic allows microphones to be connected for
inputting voice.
9) Primary (Blue) / Secondary IDE Connectors
(40-1pin PRIMARY/SECONDARY IDE)
These connectors support the provided UltraDMA/66 IDE hard disk ribbon cable.
Connect the cable's blue connector to the motherboard's primary (recommended)
or secondary IDE connector, and then connect the gray connector to your
UltraDMA/66 slave device (hard disk drive) and the black connector to your
UltraDMA/66 master device. It is recommended that non-UltraDMA/66 devices
be connected to the secondary IDE connector. If you install two hard disks, you
must configure the second drive to Slave mode by setting its jumper accord-
ingly. Please refer to your hard disk documentation for the jumper settings. BIOS
now supports specific device bootup. (Pin 20 is removed to prevent inserting
in the wrong orientation when using ribbon cables with pin 20 plugged).
TIP: You may configure two hard disks to be both Masters with two ribbon
cables – one for the primary IDE connector and another for the secondary IDE
connector. You may install one operating system on an IDE drive and another on
a SCSI drive and select the boot disk through the BIOS
IMPORTANT:
UltraDMA/66 IDE devices must use a 40-pin 80-conductor IDE
cable for 66MBytes/s transfer rates.
A7V-VM
A7V-VM IDE Connectors
16
ASUS A7V-VM User's Manual
Line Out
Line In
1/8" Stereo Audio Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
Mic