Dafra DNPB328 Посібник з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Інструменти Dafra DNPB328. Dafra DNPB328 10 сторінок. Rivnut tool
Також для Dafra DNPB328: Посібник з експлуатації (10 сторінок)
Друкувати сторінкуDNPB328 Operation Manual
TOOL CAPACITY
Blind rivnuts M3 – M4 – M5 – M6 – M8 all materials and styles.
TOOL SPECIFICATIONS
Air supply pressure:
Output traction power:
Stroke:
Net weight:
GETTING STARTED
Please refer to the TOOL EXPLOSIVE ILLUSTRATION and the PARTS LIST in this manual
in order to have a good understanding of the tool parts described. The descriptions of the tool
parts appear in this manual are in italics with the parts position numbers corresponding to the
tool explosive illustration.
1. This pneumatic powered tool should be used with a compressed air supply.
recommended to use an air hose with a diameter bigger than 8 mm.
2. Before connecting the tool to the compressed air supply, check that the compressed air
pressure is within the specified range of between 0.5Mpa ~ 0.7Mpa. Once the air pressure
has been confirmed, connect the air hose adaptor onto the tool air adaptor (#58). The air
adaptor comes in different versions in different countries. Normally the tools are equipped
with the correct version for your country as default, however, if the air adaptor you have
received does is incorrect, please contact the tool distributor(s).
3. Before using the tool, ensure that you are using the correct mandrel (#1) and anvil (#2)
according to the size of the rivnut to be set. This tool is equipped with mandrels and anvils
from M3 to M8 in the kit. For convenience, 5 identical locknuts (#65) are provided in the tool
kit for each size mandrel (#1) and anvil (#2) in pairs.
a) Remove the anvil (#2) and the locknut (#65) from the tool:
b) Remove the knurled cover (#12) and nose pedestal (#10):
0.5Mpa ~ 0.7Mpa
14,000N ~ 19,600N
1mm ~ 7mm adjustable
1.70kgs
It is