AmpliVox AirVox SW695 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система AmpliVox AirVox SW695. AmpliVox AirVox SW695 12 сторінок. Battery powered pa system with bluetooth

AmpliVox AirVox SW695 Посібник користувача
16 CHANNEL UHF WIRELESS
WIRELESS RECEIVER PANEL
Channel Display (A)
RF - Radio Frequency Indicator (B)
AF - Audio Frequency Indicator (C)
ASC / IR Auto Channel Select (Handheld Microphone Only) (D)
Select Buttons - Manual Channel Selection (E)
Mute Level Adjustment (F)
Volume Control (G)
RECEIVER / TRANSMITTER SETUP:
Make sure that you have installed the UHF antenna.
The receiver has its own POWER / VOLUME Control (G). First make
sure that you have screwed on the UHF antenna. Turn Power On. A
Frequency Channel will appear in the Channel Display (A). Press Select
Buttons (E) to select a channel. Channel number MUST match channel
number on wireless transmitter.
The transmitter bodypack is operated by 1 - "AA" 1.5 Volt alkaline bat-
tery. Slide off battery cover (H) and install battery as shown. Make cer-
tain the battery is fully seated in its compartment so the cover slides in
place easily. Battery life with alkaline batteries is approximately 8 hours
of operating time.
Select a channel (1-16) on side panel (I) using the supplied screw driver
to select channel number. Channel selected MUST match channel on
receiver. When transmitter and receiver are set to correct channel the
RF indicator (B) will glow red when transmitter is turned on.
Plug the Lapel / Headset microphone into the Mic Input Jack (K). The
microphone can be clipped to your clothing, using the supplied clip. The
lapel mic should be placed under the chin, as close to the center of the
body as possible.
Slide the power ON/OFF switch (J) to the ON position (the LED indicator
light will illuminate green). Replace batteries when this LED turns red.
● MUTE LEVEL (F) is set at min level mark (counter clockwise) when it
leaves the factory for maximum range distance. If speaker sound is
breaking up (interference noise) when speaking, turn level clockwise with
small screwdriver until condition improves. Operating distance will be
affected.
GAIN SWITCH (L): If you are a soft spoken person then set the switch to
the 10 dB position. If you are a loud speaking person then set the switch
to the -10 dB position. Adjust to prevent distortion while speaking.
WIRELESS HANDHELD MICROPHONE - MODEL SW695 ONLY
If you are using the AmpliVox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom section of microphone
and insert 2 - "AA" 1.5 Volt alkaline batteries.
IMPORTANT: Because the microphone has an AUTO SYNC function, you first select channel you wish to use on the receiver.
Then press the ASC button (D), the IR light will start to flash. Turn on microphone and point end N of microphone at the flashing
IR light on receiver and the microphone will auto sync to the same channel as selected on the receiver.
BATTERIES
1. Hold the body of microphone in hand and twist off bottom sec-
tion of microphone.
2. Insert two "AA" batteries.
3. Twist bottom section back on to microphone.
BATTERY STATUS
The life expectancy of the two batteries is about 10 hours. When the
"BATTERY" symbol on the display screen keeps flashing or light
level of screen gets very dim, the batteries should be replaced
immediately.
A
E
Wireless Transmitter - Bodypack - Model SW690 Only
Battery Cover
H
5
B
C
D
F
G
Channel Selector
I
Top Panel
L
J
K
N