AmpliVox SW800 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система AmpliVox SW800. AmpliVox SW800 8 сторінок. Battery powered pa system
Також для AmpliVox SW800: Посібник користувача (10 сторінок), Посібник користувача (8 сторінок), Посібник користувача (10 сторінок), Посібник користувача (12 сторінок)

Друкувати сторінку

AUDIO FUNCTIONS

3 MASTER AUDIO CONTROLS:

VOLUME:

This is the master volume control for the system.

BASS:

This control cuts or boosts the bass level.

TREBLE:

This control cuts or boosts the treble level.

MICROPHONE / VOICE PRIORITY SWITCH:

"ON" this feature allows a voice message to take precedence over

the musical program, without turning the music off completely. Full

volume is returned when speaking is complete.

LINE IN INPUTS:

Add pre-recorded music to your presenta-

tions from an external source such as a computer or MP3 player

can be used by connecting to the L/R RCA jacks. A separate

LINE IN VOLUME CONTROL is also provided for controlling

sound level of the external source.

WIRED MICROPHONE INPUT:

jack (this jack will accept either type microphone).

WIRED MICROPHONE VOLUME CONTROL:

just sound level of the plugged-in microphone.

16 CHANNEL UHF WIRELESS

WIRELESS RECEIVER PANEL

Channel Display (A)

RF - Radio Frequency Indicator (B)

AF - Audio Frequency Indicator (C)

ASC / IR Auto Channel Select (Handheld Only) (D)

Select Buttons - Manual Channel Selection (E)

Mute Level Adjustment (F)

Volume Control (G)

RECEIVER / TRANSMITTER SETUP:

· The receiver has its own POWER / VOLUME Control (G). Turn Power

On. A Frequency Channel will appear in the Channel Display (A). Press

Select Buttons (E) to select a channel. Channel number must match

channel number on wireless transmitter.

· MUTE LEVEL (F) is set at half way mark when it leaves the

factory. If speaker sound is breaking up, turn level clockwise with small

screwdriver until condition improves.

The transmitter bodypack (IF USED) is operated by 1 - "AA" 1.5 Volt

alkaline battery. Slide off battery cover (H) and install battery as shown.

Make certain the battery is fully seated in its compartment so the cover

slides in place easily. Battery life with alkaline batteries is approximately

8 hours of operating time.

Select a channel (1-16) on side panel (I) using the supplied screw driver

to select channel number. Channel selected should match channel on

receiver. When transmitter and receiver are set to correct channel the

RF indicator (B) will glow red when transmitter is turned on.

Plug the Lapel microphone into the Mic Input Jack (K). The microphone

can be clipped to a necktie or other clothing, using the supplied clip. The

lapel mic should be placed under the chin, as close to the center of the

body as possible.

Slide the power ON/OFF switch (J) to the ON position (the LED indicator

light will illuminate green). Replace batteries when this LED turns red.

When turned

One combination XLR / ¼"

Use to ad-

TONE CONTROL:

Use to adjust sound of plugged-in mi-

crophone.

ECHO CONTROL:

This is a sound effect feature that

makes the audio signal sound as though it's in a large area,

such as a large cathedral or a cave, by repeating the sounds

that come into the SW800 through the microphones or any of

the accessories. The listener will hear the original sound, plus

the repeated sounds created by this feature.

INPUT/OUTPUT XLR JACKS:

speaker using XLR type cable. XLR Output can also be used

to connect to other electronic devices.

LINE SET:

When using the SW800 as an extension speaker

you need to select one speaker as the "MASTER" and other

speaker/s as "SLAVE". Slide switch to the designated posi-

tion. The speaker chosen as the "MASTER" becomes the

main control for all inputs.

SLAVE INPUT CONTROL:

used as a SLAVE speaker.

Wireless Transmitter - Bodypack

Battery

Cover

Connect only powered

Use to adjust input level when

B C

Top Panel

Channel

Selector