DPCAV PANDORA Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Блок управління DPCAV PANDORA. DPCAV PANDORA 7 сторінок. Pan & tilt kit

Top Mount (Cockpit View) Assembly:

Note: Carefully review the photos shown below for details to the following assembly steps.

Install the Generic 9-Gram servo on the chassis's side panel (item 1) using two 2-56 x 3/8"

machine screws and nuts, as well as the grommets supplied with the servo. Be sure to apply

Threadlocker to the threads.

Using two 2-56 nuts (with Locktite), install

the tilt plate (item 9) onto the main chassis.

Do NOT tighten the axle nuts. Verify

correct axle placement so that the tilt plate

can smoothly swing up and down. Please

note that this configuration uses the rear

axle mounting holes, as seen in Figure 13.

If a HS-65HB servo is used, then install its

one-inch long nylon arm. Alternate: When

a generic 9-gram servo is used, the red

servo arm (item 11) is installed on the

servo's nylon wheel. Drill the wheel's holes

with a 0.064" bit and install the red arm

with two 2-56 x 1/4" self tapping screws.

Please see Figure 13 for details.

Install a DuBro mini EZ pushrod connector on the arm (drill a hole for the EZ using a 0.060"

bit). Please note that the "upper" pushrod hole is used in this configuration.

Install the pushrod as shown in the photos. The Z-bend end is placed on the Tilt panel side.

Warning: The servo arm position must be made with care to prevent damage to the servo

when it travels to its extreme positions. It will be necessary to adjust your R/C system's

EPA/ATV mix for the proper servo range.

Figure 15, Camera Full Forward

(

), www.dpcav.com

ANDORA

REV-C

Figure 14, "Top" Mount Details

Figure 16, Camera Full Down

Page 6