AMS AS6200-WL_EK_A Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Адаптер AMS AS6200-WL_EK_A. AMS AS6200-WL_EK_A 13 сторінок. Eval kit adapter board

Друкувати сторінку
AS6200 Adapter Board
2

Getting Started

The AS6200/C adapter board is ideal for rapid setup of a digital temperature sensor. To get started
connect the board to your microcontroller configuration as described in Figure 3: I²C connection.
Add a command in your source code to request two bytes from the selected I²C address. Finally
convert the returned data as described in chapter 4.2 Temperature Register to get the actual
temperature value.
3

Hardware Description

The P1 connector does provide all relevant signals which can be easily wired to a microcontroller
and power supplied with a voltage of 1.8 to 3.6V
Pin
Symbol
1
SCL
2
SDA
3
GND
4
VDD
5
IRQ
3.1

Hardware Architecture

P1 connector
Address
selector
AS6200
0
R1, R2 and R3 are pull-up resistors for the I²C interface and the Alert pin.
Depending on the application, it is recommended to either populate the decoupling capacitor C1 or
C2.
ams Eval Kit Manual
[v1-01] 2017-Dec-01
Description
I²C clock
I²C data
Ground
Power supply
Digital output pin
Table 2 Adapter board pin-out
Figure 2: AS6200 adapter board
Info
Use R1 if pull-up is required
Use R2 if pull-up is required
1,8 – 3,6 V
Alert interrupt output
Page 4
Document Feedback