Bosch Benchmark 500 Series Посібник з монтажу - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з монтажу для Духовка. Bosch Benchmark 500 Series. Bosch Benchmark 500 Series 39 сторінок. Built-in combination ovens
Також для Bosch Benchmark 500 Series: Посібник з монтажу (22 сторінок)
Друкувати сторінку
3. Place the speed microwave oven unit on top of the
universal connector brackets and fasten in place using
three screws per side. Tighten the screws securely, but
do not overtighten.
Note: The existing screws in the speed microwave
oven base help with alignment. When lowering the
speed microwave into place on the universal connector
brackets, allow these screw heads to slide into the slots
as shown in the illustration below. The screw nearest
the front of the speed microwave should slide into the
base of the slope at the front of the bracket.
4. Continue to "Connecting the Speed Microwave Oven or
Steam Convection Oven Electrical Conduit to the
Lower Oven" on page 9.
Installation with the Steam Convection
Oven
Note: Do not place the oven into the wall cabinet until after
mounting the steam convection oven on it using the univer-
sal connector brackets.
1. Remove the six screws holding the combo service slide
assemblies (A in following illustration) to the support
brackets. Use a magnetic screwdriver bit to reach the
screws through the large holes in the tops of the slides.
English 8
2. The screw in position A (nearest the inside edge, near
control panel) must be moved to allow the universal
bracket to be postioned there. Remove the inside
screw (A) from the left support bracket and reinsert it
into the third hole (B) from the inside edge of the
support bracket. Repeat for the right support bracket.
3. Reattach the slide assemblies using the holes near the
inside edge of the support bracket. Align the slide
assembly parallel to the edge of the bracket and insert
the first screw in hole (C). Insert all three screws for
each slide assembly. Tighten the screws securely, but
do not overtighten.
Note: When the correct holes are used, the front of the
slide assembly will extend just past the edge of the support
bracket. The slide assembly will also be about 1/8" (3 mm)
from the inside edge of the support bracket.
4. Install the two universal connector brackets to the slide
assemblies using the screws provided. Tighten screws
securely, but do not overtighten.
9001080875 Rev A