Alemlube 630A Технічний посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Технічний посібник користувача для Інструменти Alemlube 630A. Alemlube 630A 8 сторінок. 20v lithium-ion cordless grease gun 450g

Друкувати сторінку

OWNER'S TECHNICAL MANUAL

20V Lithium-ion Cordless Grease Gun 450g

CHARGING PROCESS

Make sure that the supply voltage is within the range specified on the charger.

1. Plug charger into the socket.

2. Insert the battery into the charger. The indicator light on the charger will change showing the status of the charging process.

Battery is charging (red light)

Charging completed (green light)

Red light flashing: battery damaged, stop charging and replace battery

3. Disconnect charger from power source and remove the battery from the charger after charging is complete.

WARNING: Charge the battery in a clean and dry place with temperatures between 10ºC and 40ºC.

The temperature of the battery and charger may increase slightly during the charging process.

The battery may not be fully charged if it is charged immediately after being used for a long period.

Allow the battery to cool to room temperature before recharging.

GREASE FILLING

INSTALLATION OF A GREASE CARTRIDGE

1. Pull the pulling rod (13) out until it is fully extended and lock the rod with the tab (14).

2. Unscrew the grease tube (12) from the gun body.

3. Remove the plastic cap from the grease cartridge and insert it into the tube (12) with the open end first.

Then remove the seal from the other end of the grease cartridge.

4. Screw the grease tube back into the gun and tighten it securely.

5. Unlock the rod (13) from the grease tube and insert it into the tube.

6. Purge any air the gun may contain. See the section "Grease gun priming".

7. Set the meter on the display to zero.

GREASE FILLING FROM A BULK CONTAINER

SUCTION FILLING

1. Unscrew the grease tube from the gun.

2. Insert the open end of the tube under the grease surface.

3. Slowly pull the pulling rod back while pressing the tube into the grease surface of the container

to prevent air from entering the tube.

4. When you have fully filled the tube and the rod is fully extended, lock the rod with the locking tab.

The tube supplied may vary depending on the model of gun. If the tube does not have a locking tab

then extend the rod until a groove is visible and move the rod sideways to lock it.

5. Screw the tube into the grease gun and tighten it firmly.

6. Release the rod and insert it into the grease tube.

7. Slightly unscrew the gun tube until some grease comes out of the end of the tube to eliminate

possible air pockets. Tighten the tube immediately.

8. Use the bleed valve to release any trapped air. See "Grease Gun Priming".

9. Clean the gun of any excess grease.

10. Reset the display meter.

NSW/ACT

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

630A

TEL: (09) 447 1007

FAX: (09) 447 1008